Selecting the correct Alert Type when Setting Up Alerts is crucial to ensure you receive the correct information. Milk is Too Warm - Recommended
Sent the first time milk temperature exceeds each MPI cooling regulation (one message per regulation broken per milking).
Milk is Too Cold - Recommended
Sent when milk temperature drops below a set temperature (one message per milking).
Sent when the stirrer is turned off while there is milk in the vat.
Milk Inlet Temperature Too Warm - Recommended
Sent when milk inlet temperature is greater than a set temperature (one message per milking).
Power Outage - Recommended
Sent when the power has been out for longer than ten minutes. Used to alert on shed power outages.
Milking End
Sent when a milking has finished. Will be sent up to 30 minutes after milking actually ended, but will contain the actual time milking ended.
Hot Wash End
Sent when a vat wash has been completed. Contains the maximum temperature the wash reached.
Milk Score Changed
Fonterra Milk Score has changed.
Vat Supply State Change - Recommended Sent when a vat supply status changes.
Blue Top Alerts
All trim plan alerts, plus:
Milk Pickup
Sent when milk has been collected.
Milking Start without Wash
Sent when a milking has started but the vat had not been cleaned.
Milk Not at Temp at End of Milking
Sent when milk temperature is above a set temperature at the end of milking.
Milking Start
Sent when a milking has started.
Power Restored
Sent when the power has been restored, if it was off for longer than ten minutes.
Vat Overfilled
Sent during milking if the vat reaches a set capacity.
Full Cream Alerts
|
|